Runco VX-40d Manuel d'utilisateur télécharger pdf (Page 48)

Installation

36 Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual

PRE

IMINAR

3.8

Turning on the Power

1. Turn on your source components.

2. Turn on the main power switch at the rear of the DHD Controller.

3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear of

the AutoScope lens motor. The lens motor power switch is located next to the AC input

(see

Figure 3-14).

4. Press the ON button on the remote control – or the POWER button on the DHD

Controller front panel – to turn on the system. The vacuum fluorescent display on the

DHD Controller front panel briefly displays “Starting Display.”

The LED status window at the rear of the projector displays an active pattern of

segments to indicate that it is changing its state from “standby” to “on.”

5. When the projector has completed its initialization and is ready

for use, “On” appears in the projector LED status window.

The fluorescent display on the DHD Controller indicates the active source, signal format

(NTSC or PAL), input resolution and aspect ratio; for example:

3.9

Selecting the Input

Source

By default, the VX-40d/-50d/-60d/-80d is configured to display the signal received on

Input 1 (RGB). To use Input 2 (DVI) instead:

1. On the DHD Controller, press MENU and enter the Service Menu passcode.

2. Select Service from the Main Menu.

3. Select Display Device from the Service Menu.

4. Press to select DVI/HDMI, then press ENTER.

Component SD NTSC 480i

Anamorphic VX-40/50 DVI

Current Source Format

Input

Resolution

Aspect Ratio

You must enter a passcode to access the Service menu.

Note

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 107 108

Pas de commentaire

Runco VX-40d Manuel d'utilisateur Page 48