Runco VX-8d Spécifications télécharger pdf (Page 36)

22 Runco VX-22i Installation/Operation Manual

PRE

IMINAR

7. Lock the lens in place by turning the

Lens Locking Nut (to the left of the lens)

180 degrees counter-clockwise. (Use a

6.0mm hex wrench.)

8. Replace the Lens Cavity Front Cover.

9. Reattach the Projector Front Jewelry by sliding the top down onto the two retaining

dowels. Tighten the Phillips screw at the top of the projector to secure it.

10. Remove the Front Lens Cap.

3.5

Installing the Optional

CineWide Lens Mount

If you are installing a standard (non-CineWide) VX-22i, skip this step and proceed with

Mounting the VX-22i (page 27).

If you are installing a VX-22i/CineWide, proceed with Installing the Fixed CineWide

Base Plate (VX-22i/CineWide) (page 26).

If you are installing a VX-22i/CineWide with AutoScope, proceed as follows to install the

AutoScope lens motor.

Make sure to route the wire harness in its original position and away

from the moving lens stages and Motor Assembly, to prevent

unexpected disconnection or lens damage.

Caution

1. Do not install the CineWide lens yet, only the fixed CineWide

base plate or AutoScope lens motor. You will install the CineWide

lens after you install the projector and adjust the primary lens.

2. Some components shipped with your projector may differ slightly

from what is shown in these instructions.

Note

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Pas de commentaire

Runco VX-8d Spécifications Page 36