Runco VX-8d Spécifications télécharger pdf (Page 22)

8 Runco VX-22i Installation/Operation Manual

PRE

IMINAR

2.3

VX-22i Rear Connector

Panel

Figure 2-3 shows the rear connector panel on the VX-22i, and the paragraphs that follow

describe them.

Figure 2-3. Rear Connector Panel

1. HD2 INPUT

Five BNCs for connecting either RGB or component high-definition sources (up to

1080p). The VX-22i automatically detects the input signal resolution.

2. HD1 INPUT

Five RCA-type connectors for either RGB or component high-definition sources (up to

1080p). The VX-22i automatically detects the input signal resolution.

3. SERVICE ONLY

For future use.

4. WIRED REMOTE

Wired input from an external remote control or infrared receiver. It is a 3.5-mm, mini

phono jack, wired as follows:

Ring = +5V

Tip = IR Input (TTL level)

Sleeve = Ground

5. RS-232/485 CONTROL PORT

A male, 9-pin D-sub connector for interfacing with a PC or home theater

automation/control system. (Currently, only RS-232 interface is supported.)

6. 12-VOLT (750 mA) TRIGGER OUTPUTS

Connection for up to three (3), 12-volt trigger-controlled devices. These can be

retractable screens, screen masks or the Runco CineWide with AutoScope system.

For best results, do not run your DVD player in progressive mode.

When an external remote control or infrared receiver is connected

to the wired IR input, the IR sensor on the front of the VX-22i is

disabled.

WIRED REMOTE

HD2 (BNC)

HD1 (RCA)

HD2 (BNC)

HD3 (VGA / Y-Pb-Pr)

Service port.

Not for user

access

10 9 8 7 6 5 4 3

Tip

Note

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 87 88

Commentaires sur ces manuels

Pas de commentaire

Runco VX-8d Spécifications Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs de données Runco VX-8d