Runco VX-8d Spécifications télécharger pdf (Page 27)

Runco VX-22i Installation/Operation Manual 13

PRE

IMINAR

3.1

Remote Control

To install batteries in the remote control,

press up on the battery cover retainer clip

and lift off the cover. Install the two AAA

batteries with the correct polarity and then

replace the cover.

Notes on Batteries• Make sure that the battery polarities are correct when installing the batteries.

• Do not mix an old battery with a new one or different types of batteries.

• If you will not use the remote control for a long time, remove the batteries to avoid

damage from battery leakage.

Notes on Remote Control

Operation

• Make sure that there is nothing obstructing the infrared beam between the remote

control and the IR receiver on the projector.

• If the effective range of the remote control decreases, or it stops working, replace the

batteries with new ones.

• The remote control may fail to operate if the infrared remote sensor is exposed to bright

sunlight or fluorescent lighting.

• Ambient conditions may possibly impede the operation of the remote control. If this

happens, point the remote control at the projector, and repeat the operation.

3Installation

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 87 88

Pas de commentaire

Runco VX-8d Spécifications Page 27