Runco REFLECTION CL-510 Spécifications télécharger pdf (Page 66)

Installation

54 Runco SC-1 Owner’s Operating Manual

PRE

IMINAR

3.13

Calibrating Projector

Input 2 (DVI)

After you have installed and adjusted the projector and lens (or lenses), you are ready to

begin calibrating the DVI input (Input 2) to the SC-1.

To perform the calibration, you will use the SC-1 built-in keypad (Figure 2-3) or

TheaterMaster Remote Control, shown in Figure 3-29 and described on the pages that

follow. Once you have completed the projector input calibration, the end user can use the

DHD Controller Remote Control (

Figure 2-6) to adjust input image quality, change aspect

ratios, switch between sources and more. (The exception to this rule is when sources are

connected directly to the projector. Although this is technically possible, Runco advises

against this.)

Runco calibrates both the SC-1 and DHD Controller at the factory

for optimum performance in most typical home cinema

environments, before the system ships.

Carefully assess the displayed image quality before proceeding with

calibration. In most cases, it is not necessary to calibrate the

projector inputs, as the DHD Controller gives you as much control

as you will need over the image quality.

Only ISF-certified installation technicians should attempt the

calibration procedures described here, and ONLY if absolutely

necessary to accommodate an atypical installation.

Note

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 125 126

Pas de commentaire

Runco REFLECTION CL-510 Spécifications Page 66