Runco REFLECTION CL-510 Spécifications télécharger pdf (Page 59)

Installation

Runco SC-1 Owner’s Operating Manual 47

PRE

IMINAR

3.10

Adjusting the Picture

Orientation

By default, the SC-1 is configured for a “floor/front” installation, in which the projector is

installed upright and in front of the screen. If it is installed behind the screen, you must

switch to a “floor/rear” picture orientation. To do this:

1. On the DHD Controller, press MENU and enter the Service Menu passcode.

2. Select Service from the Main Menu.

3. Select Display Device from the Service Menu.

4. Select Configure from the Display Device menu, then select Installation.

5. Choose Floor/Rear.

3.11

Primary Lens

Adjustments

This initial optical alignment procedure is the foundation for optimizing your displays,

ensuring that images reflected from the DMDs are parallel to and well-centered with both

the lens and screen.

Before you begin, properly position the

projector relative to the screen (refer to

Vertical and Horizontal Position on

page 22).

Double-check projector leveling (refer to

Adjusting the Feet on page 31) so that the

top edge of the image is parallel to the top

edge of the screen.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 125 126

Pas de commentaire

Runco REFLECTION CL-510 Spécifications Page 59