Runco REFLECTION CL-510 Spécifications télécharger pdf (Page 57)

Installation

Runco SC-1 Owner’s Operating Manual 45

PRE

IMINAR

Power-Up Sequence1. Turn on your source components.

2. Turn on the main power switch at the rear of the DHD Controller.

3. If this is an AutoScope-equipped projector, turn on the main power switch on the

AutoScope lens motor. The lens motor power switch is located next to the AC input

(see

Figure 3-19).

4. Press the ON button on the remote control – or the POWER button on the DHD

Controller front panel – to turn on the system. The vacuum fluorescent display on the

DHD Controller front panel briefly displays “Starting Display.”

The LED status window at the rear of the projector displays an active pattern of

segments to indicate that it is changing its state from “standby” to “on.”

5. When the projector has completed its initialization and is ready

for use, “On” appears in the projector LED status window.

The fluorescent display on the DHD Controller indicates the active source, signal format

(NTSC or PAL), input resolution and aspect ratio; for example:

Component SD NTSC 480i

Cinema SC-1

Current Source Format

Input

Resolution

Aspect Ratio

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 125 126

Pas de commentaire

Runco REFLECTION CL-510 Spécifications Page 57