Runco RS232 Guide d'installation télécharger pdf (Page 8)

Using the Operation Commands Table

8 RS232 Control

Using the Operation Commands Table

The Operation Commands table starts on page 19.

Operations and Operation Numbers

The commands are listed in alphabetical order by Operation. In a command, you may

use either the ascii text of the operation or its Operation Number. For instance, to

get the tile power, all these commands are equivalent:

op A3 display.power ? [CR]

opA3display.power? [CR]

op A3 1094 ? [CR]

opA31094? [CR]

OP A3 dIsplAy.Power ? [CR]

Target

If the Target column has anything in it, the command must use one (and only one) of

the targets, and it must be in parentheses. Use either the ascii text or the Target

Number. These are equivalent commands:

opa2 center.point (red) ? [CR]

opa21110(0)? [CR]

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

Pas de commentaire

Runco RS232 Guide d'installation Page 8