Runco RS232 Guide d'installation télécharger pdf (Page 15)

Examples of Operation Commands

RS232 Control 15

Examples of Operation Commands

Recalling Memories

Remember: The slot target number used in the command is one less than the memory

slot number as seen in the menus. For example, to recall memory slot #40, in

commands you’d specify slot.target = 39. Likewise, to recall the first slot,

you’d specify slot.target = 0.

Recalling Memories Directly

Use slot.recall ( ). Put the memory number (minus 1) in the parentheses.

What is the difference between slot.recall.target and slot.target?

Assume that memory slots #1, #2, and #6 are used (full). Memory slots #3, #4, and #5

all the others are empty, as shown in the illustration below:

The following series of example commands show the difference between

slot.target and slot.recall.target and which memory slot the

command is pointing to.

▲

1 2345678

op A1 slot.target = 3 [CR]

This sets the memory slot to #4 in tile A1. Any further

commands that need a memory slot will use this one

until it is changed.

1 2345678

op A1 slot.action (save) [CR]

This saves all the current settings into memory

slot #4 with the default memory name.

1 2345678

op A1 slot.target = 4 [CR]

This sets the memory slot to #5, which is empty.

1 2345678

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Pas de commentaire

Runco RS232 Guide d'installation Page 15