Runco VX-2000d Manuel d'utilisateur télécharger pdf (Page 20)

Controls and Functions

8 Runco VX-2000d Owner’s Operating Manual

PRE

IMINAR

2.3

DHD Controller Front

Panel

Figure 2-3 shows the controls and indicators on the DHD Controller front panel; the

paragraphs that follow describe them.

Figure 2-3. DHD Controller Front Panel

1. RUNCO ICON

Lights red to indicate that the DHD Controller is in standby mode; lights blue to

indicate that the unit is on.

2. POWER BUTTON

Press once to toggle from standby mode to on mode. Press it again to return to

standby mode. For a discrete on or off command, you can use the direct access

buttons on the remote control.

3. IR SENSOR

Receives IR commands from the remote.

4. VACUUM FLUORESCENT DISPLAY

Can be used instead of the On-Screen Display (OSD). Displays currently-selected

menu or – if no menu is selected – the current source, signal format (NTSC or PAL),

input resolution and aspect ratio.

5. UP BUTTON

Used to direct select aspect ratios or move the menu cursor up in the OSD. When no

menu is present on-screen, the UP button toggles through aspect ratios in the

following order:

Anamorphic - Standard (4:3) - Letterbox - VirtualWide - Cinema - Virtualwide 2.35

6. LEFT BUTTON

Used to direct select inputs or move the menu cursor left in the On-Screen Display.

When no menu is present on-screen, the LEFT button toggles through the different

sources, in this order:

HDMI 2 - HDMI 1 - HD/RGB 2 - HD/RGB1 - Component SD - S-Video 2 - S-Video 1

- Composite

Virtualwide 2.35 is available only on the VX-2000d/CineWide and

only on the analog inputs (HD/RGB, SD Component, Composite

and S-Video). For more information about aspect ratios, refer to

Table 4-1.

Note

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Pas de commentaire

Runco VX-2000d Manuel d'utilisateur Page 20