Runco REFLECTION Spécifications télécharger pdf (Page 43)

Installation

Runco RS-1100 Series Owner’s Operating Manual 31

PRE

IMINAR

Connecting to AC PowerProjector: The RS-1100 ships

with various types of AC power

cords. Choose the one that is

appropriate to your locale.

Plug the female end of the power

cord into the AC receptacle on the

rear of the projector (AC 100V ~

240V). Then, connect the other end

to your AC power source.

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power

cord is provided for the lens motor. Plug the female end of the AC power cord into the AC

input on the rear of the lens motor assembly. Connect the other end to a 110

VAC power

source.

3.7

Turning on the Power

1. Turn on your source components.

2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear

of the AutoScope lens motor. The lens motor power switch is located next to the AC

input (see above).

3. Turn on the main power switch at the rear of the projector. The POWER LED lights

orange. The LAMP and TEMP LEDs light red briefly, then go out.

4. Press the ON button on the remote control to turn on the RS-1100. The POWER LED

flashes orange to indicate that it is warming up.

5. When the projector is ready for use, the POWER LED lights green.

6. “Searching...” appears on the screen before the RS-1100 identifies the input signal

and remains there until a valid signal is detected.

7. If an incompatible input signal exceeds the range of the projector, a “No signal

supported" message appears on the screen. This message remains on the screen

until you change the input signal.

The input voltage to the AutoScope lens motor must be between

100 and 120 VAC. Do not connect the AutoScope lens motor

to a 200-240

VAC power source!

Power

switch

Caution

AutoScope Lens Motor (Rear)

AC Input

Power

Switch

110 VAC

Power

Downloaded From projector-manual.com Runco Manuals

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Runco REFLECTION Spécifications Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs de données Runco REFLECTION