
Installation
22 Runco RS-1100 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Remove Projector Front
Feet
Place the projector upside down on a blanket
or other soft surface. Then, remove the two
front feet by turning them counter-clockwise.
Install Anamorphic Lens
Motor
Line up the eight mounting holes on the lens motor housing with those on the bottom of
the projector. Secure the motor to the projector with the eight screws provided for this
purpose, as shown in
Figure 3-6.
Figure 3-6. RS-1100 Ultra with AutoScope Lens Motor – Bottom View
➤
➤
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies
are both fully assembled.
DO NOT OVER-TIGHTEN THE SCREWS.
Note
Caution
Downloaded From projector-manual.com Runco Manuals
Commentaires sur ces manuels