Runco VX-60d Spécifications télécharger pdf (Page 60)

Installation

44 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual

PRE

IMINAR

“Keystoning” usually occurs when the projector is tilted relative to the screen. “Pincushion”

distortion can sometimes occur if the throw distance is very short and/or the projector is

equipped with an anamorphic lens.

To correct keystoning or pincushion distortion:

1. On the DHD Controller remote control or front panel, press MENU.

2. Select Calibration from the Main Menu and enter the Calibration Menu passcode.

3. Select Image Alignment from the Calibration Menu.

4. Select Corner Alignment to correct a “keystoned” image by adjusting the image

corner positions. Select Midpoint Alignment to correct pincushion distortion by

adjusting the image edge mid-points. See Figure 3-22.

Figure 3-22. Image Alignment Controls

You must enter a passcode to access the Calibration menu.

Use the built-in test pattern when adjusting the image corners or

midpoints. To access it, check the Test Pattern box in the Corner

Alignment or Midpoint Alignment menu.

Note

Tip

Top Left (x, y)

Left

Middle (x)

Left/Right

Middle (y)

Right

Middl

(x)

Bottom Left (x, y)

Top Right (x, y)

Bottom Right (x, y)

Top/Bottom Middle (x)

Top Middle (y)

Bottom Middle (y)

Notes:

1. Smaller “x” values move a point to the left; larger values move it to the right.

2. Smaller “y” values move a point up; larger values move it down.

Center

(x, y)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 125 126

Pas de commentaire

Runco VX-60d Spécifications Page 60