Runco VX-2i Spécifications télécharger pdf (Page 63)

Installation

Runco VX-6000d Installation/Operation Manual 47

PRE

IMINAR

Configure Lens Motor

Trigger (CineWide with

AutoScope)

(Skip this step if you are installing a fixed CineWide anamorphic lens.)

CineWide with AutoScope maintains constant image height independent of the aspect

ratio, while using the full display resolution of the projector. It accomplishes this by moving

the anamorphic lens in front of the primary lens when widescreen material is being viewed.

When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens

moves out of the light path.

To configure the lens motor trigger on the DHD Controller for proper AutoScope

operation:

1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.

2. On the DHD Controller remote control or front panel, press MENU.

3. Select Service from the Main Menu and enter the Service Menu passcode.

4. Select Trig gers from the Service menu.

5. Assign the trigger output to which the lens motor is connected to the Cinema and

Virtual Cinema aspect ratios. This enables the lens motor to move the anamorphic

lens into position (in front of the primary lens) when either aspect ratio is selected.

6. Select the Cinema aspect ratio to move the anamorphic lens into position, if it isn’t

already. To do this, press CINEMA on the DHD Controller remote control (

Figure 2-5),

or press or repeatedly with no menus visible on-screen.

Adjust the Anamorphic

Lens

Adjusting the Horizontal (X) Lens Position:

1. Project a white field on the screen.

2. Loosen the Yaw/X-Adjustment Levers underneath the lens.

3. Slowly move the anamorphic lens into place so that there are no shadows on either

side of the screen:

4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to

secure the lens in place.

You must enter a passcode to access the Service menu for the first

time after turning on the system.

Note

Too Far Right

Too Far Left

Correct position

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 111 112

Pas de commentaire

Runco VX-2i Spécifications Page 63