Runco VX-3C Spécifications télécharger pdf (Page 32)

2-26

INSTALLATION AND SETUP

Figure 2.24. Independent Keypads and Projectors

Remote Keypad! Protocol - IR OR WIRED KEYPAD -

The standard IR remote keypad or the optional wired remote can be set to one of two different

protocols - “A” or “B”. To hard-wire a protocol to “A” or “B” in either remote, follow Steps 1

through 5:

Step 1

Unplug the keypad from the projector (applies to wired remote only).

Step 2

Unlatch and open the empty battery compartment on the back of the keypad as shown in Figure

2.25.

NOTE: A wired keypad opens as shown, but a cable passes through the battery compartment

cover.

Figure 2.25. Opening the Keypad

Step 3

Find the 4 jumpers located along the latching side of the battery compartment. These jumpers set

the keypad protocol and other settings so that the keypad functions in a certain manner.

Step 4: Set the Jumpers

Set the jumpers as shown in Figure 2.26. Take care to refer to the correct part of the drawing - IR

or wired (optional). Use tweezers or needle-nose pliers to remove and replace each jumper as nec-

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 128 129

Pas de commentaire

Runco VX-3C Spécifications Page 32