Runco VX-22D Manuel d'utilisateur télécharger pdf (Page 51)

Installation

Runco VX-22d Owner’s Operating Manual 39

PRE

IMINAR

3.11

Installing and

Adjusting the

CineWide Anamorphic

Lens

If you are installing a CineWide-equipped projector, proceed as follows to install and

adjust the anamorphic lens.

Attach Lens Mounting

Assembly to Lens Motor

Carriage Plate

The VX-22d Anamorphic lens mount kit consists of everything shown in Figure 3-16.

Some components shipped with your projector may differ slightly from what is shown in

these instructions. If any items are missing or damaged, please contact your Runco dealer

or Runco Customer Service at (800)

23-RUNCO.

Figure 3-16. VX-22d Anamorphic Lens Mounting Assembly - Exploded View

1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the

Anamorphic Lens Holder (item #5).

2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).

Position the bracket so that the long slot at the bottom of the lens holder is

perpendicular to the corresponding slots on the carriage plate.

3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers

(item

#6) and Yaw/X Adjustment Levers that you removed in Step 1.

It is extremely important that the primary lens is properly

adjusted before you install the anamorphic lens. Ensure that

the image from the primary lens is perfectly centered on the

screen.

Note

Pitch Adjustment Yoke for Lens

Height/Y Adjustment

T-Screw (2x)

Pitch Adjustment

Anamorphic Lens

Holder

1/4-20 Hex Bolt (2x)

and Washer (2x)

AutoScope Carriage Plate

Yaw/X Adjustment

Lever (2x)

Lens Adapter Ring and

Mounting Screws (3x)

Pitch Adjustment

T-Nut (2x)

Anamorphic Lens

Set Screw

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Runco VX-22D Manuel d'utilisateur Page 51

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs de données Runco VX-22D