Runco SC-50D Manuel d'utilisateur télécharger pdf (Page 98)

Maintenance and Troubleshooting

82 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual

PRE

IMINAR

5. Install the new lamp:

a Take care to align the new lamp properly in the correct orientation inside the lamp

compartment.

b Press firmly on the lamp to properly seat it.

c Secure the lamp by tightening the three (3) captive screws.

6. Close the lamp compartment cover and tighten the captive screw.

7. Re-attach the Left (Exhaust) Side Panel to the projector.

The lamp will automatically turn on again when the cover is closed.

Note

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 123 124

SC-50d Series 1
SC-60d Series 1
Warranty 3
Important Safety Instructions 7
Compliance Information 8
Table of Contents 11
List of Figures 15
1. Introduction 17
Using This Manual 18
Description, Features 19
Introduction 20
2. Controls and Functions 21
SC-50d/SC-60d Input 22
Controls and Functions 23
DHD Controller Front 24
DHD Controller Rear 25
Remote Control Units 27
3. Installation 31
Quick Setup 32
Installation 33
Considerations 33
Estimating Throw Distance 34
Throw Distance (TD) = 34
Ceiling Installation 35
Floor Installation 35
Installing the Primary 41
Projection Lens 41
Installing the Optional 42
AutoScope Lens Motor 42
Mounting the 43
Connections to the 45
SC-50d/SC-60d and 45
Figure 3-14 50
Audio Processor/ 52
Switcher 52
Secondary Display 52
Control System 53
IR Sensor 55
IR Repeater 55
Remote Control 55
Ferrite sleeveAC power cord 56
To power outlet 56
To Projector AC IN 56
16:9 1080i/60 57
Adjusting the Picture 58
Orientation 58
Adjusting the Image 59
Geometry 59
Installing and 61
Adjusting the 61
CineWide Anamorphic 61
Too Far Right 63
Too Far Left 63
Correct position 63
Too High 64
Correct Lens Angle 64
Incorrect Lens Angle 64
Anamorphic Lens (Top View) 65
Working With the 66
4. Operation 67
Operation 68
4:3 Image on 70
16:9 Display 70
(Letterbox aspect ratio) 70
1080i HDTV Image 71
720p HDTV Image 71
Below Black 72
Input Names 87
Lamp Compartment Cover 97
Retaining Screw 97
Troubleshooting Tips 99
6. External Control 101
Table 6-1. Serial Commands 102
Using Discrete IR 106
Start Bits Toggle Bit 107
Address Bits Command Bits 107
11010001000001 107
Using HDMI CEC 110
Messages 110
External Control 112
7. Specifications 113
DHD Controller 115
Specifications 115
SC-50d/SC-60d 117
Dimensions 117
Dimensions with 118
CineWide with 118
AutoScope Assembly 118
Supported Timings 119
020-1105-00 Rev. A 124
March 2011 124

Commentaires sur ces manuels

Pas de commentaire

Runco SC-50D Manuel d'utilisateur Page 98

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs de données Runco SC-50D