Runco QUANTUM Q-750D Spécifications télécharger pdf (Page 30)

Installation

14 Q-750d Series Installation/Operation Manual

PRE

IMINAR

3.2

Quick Setup

Table 3-1 gives a quick overview of the Q-750d installation process. The sections

following this one provide detailed instructions.

Table 3-1. Installation Overview

Step Procedure

For Details, Refer to

page...

Choose a location for the projector 15

Install CineWide lens mounting assembly (stationary base

plate or AutoScope lens motor – optional)

Mount the projector 28

Connect the DHD Controller to the projector 29

Connect signal sources to the DHD Controller 31

Connect external controller to RS-232 port (optional) 36

Connect 12-volt trigger outputs to AutoScope lens motor

and/or other equipment (optional)

Connect projector, DHD Controller and lens motor (if

present) to AC power and power up

Primary lens adjustments: projected image size (zoom),

position (shift) and focus

18, 40

For rear-screen and/or ceiling-mount installations, select

the proper picture orientation

Install CineWide anamorphic lens (optional) 41

CineWide lens adjustments: position, pitch (angle),

geometry and focus

Display calibration: adjust the following for each input and

display mode (resolution and frame rate); save settings

when finished:

• Aspect ratio

• Brightness

• Contrast

• Color level

• Tint

• Sharpness

• White Balance

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 105 106

Pas de commentaire

Runco QUANTUM Q-750D Spécifications Page 30