Runco LIGHTSTYLE LS-HB Spécifications télécharger pdf (Page 75)

Operation

Runco LS-HB/LS-HB Ultra Installation/Operation Manual 59

PRE

IMINAR

Figure 4-7. Source Select Sub-Menu

PIP Select: To select a PIP (secondary) video source, press or to highlight PIP

Select, then press ENTER. The default PIP selection is Off.

All sources that are not available per the source enable function (refer to Source Enable

on page 65) are grayed out.

All sources that cannot be used for PIP due to a shared electronic path with the Active

source are grayed out. The PIP source is a saved setting for each source, like brightness

and contrast.

If for some reason the current PIP source becomes invalid (by disabling it in the source

enable menu, for instance), PIP Select automatically resets to Off.

Resync: If the projected image becomes unstable or degraded, press or to highlight

Resync, then press ENTER. This causes a re-acquisition of the active source and the PIP

source, if present. It also changes any Fine Sync settings (described on page page 63) for

this timing to the default setting.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 111 112

Pas de commentaire

Runco LIGHTSTYLE LS-HB Spécifications Page 75